Saturday, April 13, 2013

Puerto Azul 13 April 2013

We decided to spend Saturday at the Puerto given the turnout we had on our last trip. We motored to the spot that has been constantly hot hence its name on my GPS is "Kalan" . Water depth was about 6 feet with a rocky bottom. Threadies stay in the area and from the stomach contents of the specimens I've caught are evidently feeding on squid..

This however did not deter them from chasing topwaters. The moment we dropped anchor and casted, six fish took turns chasing our lures attacking them in unmamali like manner. They would strike a lure again and again until  hooked. Gret hooked up to a mamaw of around three kilos which I lost while landing ( sorry agian, Gret). Another of her hookups, after exploding on her lure three times and finally finding the mark, turned on the afterburners and headed for the deep. after a really long run which nearly stripped the reel the monster came unbuttoned.

 Gret was pretty quiet for the whole trip after the incident and I pretty much stayed out of her way.

I had two strikes and both hooked up. My fish though were way smaller than the monsters on Gret's popper.

 Squid seems to be a major part of their diet in the area.
Grilling the yummy fish!


Gret's lost 3 kilo threadie.

Wednesday, April 10, 2013

El Puerto Azul

The place never lets me down...almost.
Another trip that started late. Gret's attempts at waking me at 4 a.m. were futile. The past night's labor  (loading the boat,gear and tackle) had put me in a stupor that would not be broken even by the scream of a Penn International's clicker. Finally, at 5 a.m., the smell of coffee inches from my nostrils jump started my neurons.

 I fell off the sofa and crawled my way to the bathroom. The warm water brought all my senses online and a shot of coffee fired up the furnace.

 After a pleasant drive through EDSA ( it was a holiday) and an exhilarating run through CAVITEX ( I was charged as CLASS I with my boat on the roof. HOORAY!)  we arrived at our destination.

 I had no intention of actually using the boat this time but a group of Caviteno anglers had beat us to my favorite spot so down went the boat.

After a hectic 15 minutes of setting up, we finally pushed off, motored to a spot near the cliff north of the pier and started casting. Gretchen got first strike on her popper and I hooked up on my spoon. The fish made several commendable runs and two jumps before succumbing.

Gretchen took my baitcaster and started working the spoon as I bled the fish. A few casts later, she hooked up to her own threadie.
I switched to my Swinghead Jig with a Bass Assassin tail and landed fish number three.
By this time, the wind had picked up and was overwhelming our homemade anchor. Even with its long rode, we had to re anchor three times ( time to make a decent anchor).  I decided to move to the lee side of the pier where wind was less of a problem. This side of the pier has a lot juvenile lapu lapu.

Gretchen switched to a Berkeley shrimp while I stuck to the Swinghead. A baby lapu lapu inhaled my rig on the first cast...what its intentions were with a meal nearly as big as it was, was beyond me. After an hour of drifting the area and hooking nothing else but bottom, we decided to beach the rig.

 After loading the boat and finishing off a meal I set up my Majorcraft Crostage rod. this was the first time for me to try the new rod even if I've had it for quite some time. Gretchen opted to take a siesta under the mango tree, the green fruits seemed to be of more interest to her than bleaching under the blazing sun.

The Cavitenos were still there with their phalanx of rods bristling the pier. After smiles and introductions, I asked permission to cast from a rock situated between two of their rods. This was slightly uncomfortable for me as decades of lurecasting has taught me that casting lures and worse catching fish in an area were others have baited rods out can lead to misunderstandings but the group was the friendly sort so I took the risk...

 A few casts out and I knew the Shimano Speedmaster reel/ Crostage 7'9" rod were sweethearts from birth and the 22gram jig was their lovechild. The rod launched the jig out with an ICBM's trajectory while the reel would bring it back riding shotgun in a Ferrari.

This was the retrieve the threadies wanted...
Three threadies struck in succession in less than an hour of casting. The Cuda took more coaxing. I had noticed baitfish jumping in a spray pattern rather than in the regular forward fleeing motion. I knew from experience that this was due to predators attacking straight up from below and only cudas do this. They often go airborne in their attacks and come down on their prey.

 I slowed the retrieve but kept it erratic with sweeps and and short pulls of the rod. strike one resulted in foam and a flash of yellow tail. minutes later strike two was a huge splash but a miss just the same. Strike three was spectacular, the cuda switched tactics and took to the air divebombing the hapless jig from above. Hookup! I had misjudged the size of the cuda, hammerhandle turned out to be pick axe handle, good sized!. The fight took time and I eased off the pressure not wanting to bring the toothy critter to the rocks green.

By this time the Cavitenos took cue and one of them had a new unused jig with him. He started casting in the spots I was working and blissfully hooked up to what turned out to be the last fish for the day. It's always nice to see new lure converts and now, I figure, less rods will be porcupining the pier .

Took some video this time. https://www.facebook.com/pages/Haruan-Hunter-Store/464029106950250

Some Tips: There's no need to keep blindcasting an area, fish intelligently and with the tides. Keep your senses aware. When predators are lurking baitfish act differently. Puerto Azul has bites at certain, almost fixed hours (non tide related).

Monday, March 25, 2013

Zambales Adventure

There's a place in Zambales where islands dot the seascape. Reefs extend to the horizon. Dark mysterious rivers empty into quiet estuaries... all waiting to be explored!
 The ferry banka.
 Crossing over. It's a 20 minute run to the island. Could be faster but the route is full of shallow reefs.
 One of the numerous  rivers that run across the highway.

 Working the flats
 Juvvie groupers again!
 Rigged and ready.

 Gotta watch out for these guys. The moment you turn your back they grab your shoes and send you off on a halfday treasure hunt.
 Manta rays were jumping all over the place.
 Idyllic.
 You can beach anywhere, though the west end of the island is covered with mangroves and  shallow coral.
 Shorejigging babe with jack.

Sandugo watershoes rock! Used to buy the really expensive variety but this local brand does everything for a third of the price.

5hp. outboard is the bare minimum. It can push the 12 footer at decent speed and sips gas at a forgettable rate allowing you to go far on a little plus the engine is light, easy to portage. I want an 8hp. but the budget is still at the horizon...

Topwaters, spoon and casting jigs scored. Light casting tackle for the chore. If you want to tangle with the GT's on the troll bring bigger guns.

We barely got to tap into the beauty of the area. The rivers with their resident snappers and barra will have to wait for our next trip...

Monday, February 25, 2013

Setting Up The Boat

It takes me 15 minutes to get from this...
 ...to this.
Loaded in the boat are:
1. 5hp. outboard
2. Bowmount trolling motor
3. Paddle
4. Battery
5. Anchor w line
6. Possibles bag ( containing tools, engine essentials, extra anchor line, net bag for emergency anchor mixing oil, emergency equipment etc).
7. Provisions Food, Water, Fuel
8. Fishing Tackle.
9. Lifevest

Sunday, February 17, 2013

Puerto Azul

This resort has been around for quite some time. Few people fish the area now which is a puzzle as the place is near (50km. from my house) and actually has fish! Barracudas, Jacks, Threadfins, Groupers, Snappers, Sharks and Rays to name a few, inhabit the place. The resort has a boat ramp and a decrepit pier which holds a lot of baitfish.

Here are a few pics of what you can catch there:

 The hungry juvies grab the lures before momma grouper can have a shot at it.

Threadie on topwater.
 My 12footer rigged out. Note: My 2hp. comes along until I get the bowmount motor attached.

 This draw stares on the road. Hopefully it starts an interest in the sport
 Opening to the bay from the planned marina at Puerto Azul.

More yummy threadies!

When the easterlies weaken (around March) I plan to explore the shoreline from Puerto Azul to Caylabne.

My Second Aluminum Boat

This has been up for sale for sometime and I've been resisting the urge to acquire it. Time came when I had a little extra so...
 It was the Bimini top that hooked me.How could you resist it?Looks like a cute buggy you can drive around in.
 It's a really beamy boat. Typical solid Aussie construction. The transom and gunwales are higher on this boat. Definitely a drier ride than the Alcraft.
 It was a struggle getting it off the roof and I figured out why. The flooring weighed a lot! The hull above the waterline is in great condition. The previous owner spent on getting it finished nice in khaki. Unfortunately, I see some possible issues on the bottom. Some small damages, possibly small holes repaired with epoxy. Fortunately I have a friend who does aluminum welds so I'll deal with any leaks when they arise.
 Drove all the way to San Jose, Nueva Ecija to pick up the boat.  I need longer rails for my roofrack to properly handle this boat.

My First Aluminum Boat

My First lasted all of 1 day as I resold it (at a profit of course) to acquire one that could go on my roof...a free boat!
 A pretty rig but but around here what you need is a boat you can carry on your roof and self launch
So, I sold that and got this old Alcraft rivet bucket.
Some dent removal and a paint job to make the old hull presentable
Setting the boat up. I need an 8-15hp. outboard, a bow mount trolling motor, some wired lights and a bilge pump. It's a work in progress.

Feb.19,2013

Made a platform for my bowmount trolling motor.



Feb.20,2013

Attached the motor!

I used 18mm. marine ply for the platform. I still need to get the quick release mount but for now, I'm using wing nuts and lock washers to speed setting up...also need a decent battery box. The whole system (motor, platform and battery weighed in at 35 kilos.

Wired Led lights below the bow's overhang from this position they are visible but won't mess with my night vision. I ran the wires through clear tubing and sealed the ends with silicon sealant. I've also ran wires to the stern for the light and bilge pump. It was a pleasant surprise to find out that the 5hp Mercury belts out a few amps of 12V when running. It's got an alternator!

Feb.21,2013
Set up the wiring and placed tiedowns for the paddle.


My phone got a dunking last time out even if it was in a dry pouch so I decided to put a small watertight compartment on the boat.

It's from an old jetski. Cutting a perfectly good thwart/bench did not sit well with me but I did what had to be done.

March 5,2013
Added a quick release mount for the trolling motor.

March 8,2013
 Mounted my switches. These are toggles with water resistant rubber boots. A bit pricey but should last longer than regular ones.
Put binding posts on my battery box. This way I don't need to open the box to access the battery.
A little creature comfort...
March25,2013
Found a NOS humminbird for cheap.

added some fish stickers to the bottom of the hull to encourage baitfish to shelter under and to attract predators